GE 2-9200 - Manual (Page 9)

IN CASE OF DIFFICULTY
Should your phone not operate properly, follow the Service
Check List. If still inoperative, disconnect the phone and try
another phone (if one is available) or another cord to
determine whether the problem is in the telephone, the cord or
the line. If irf the phone, discontinue its use and follow the
SERVICE procedure in this manual. If in the line, notify the
telephone company immediately. The telephone company will
charge for a service call if the problem is attributable to
equipment you own.
SERVICE CHECKLIST
In case of difficulty, check the following before seeking service.
PROBLEM SOLUTION
1. No dial tone. • Check Cords: Are they inserted pro-
r%rr\r\Ar4i# r\r\rA ir/-ik
/0
A
pi \y cu lu ocuui cty ! rM ^ u ic?y ucii
1
id^eu i
•Check HOOK SWITCH: Does it fully
extend when Handset is lifted from cradle
2. Phone does not
dial out.
• Check PULSE/TONE switch. Is it in
TONE position which may not be
rYMTinatlKlo \A/lfH \/r\i ir rliolinn 1
fTiu
1
jr\,rwii wiuiii
1
^
0^1
:
3. Phone does not
ring.
• Is RINGER SWITCH in OFF position?
• Ard i//^i
1
iicirkn ^r\r\ mom/
- ywu iv.>rv^ iiidiiy pi IV/t
1^0
Ul
1
W
1
lO
line? (The total REN of all phones on the
same line should not be greater than the
mavimi im'PPA/ fnr v/niir r'allinn aroa Qaa
■ * tM#%ii • IMI ■ ■ • « IVI J Wl Wllll Ul VIA* WWV.#
FCC Registration Information on page 12.)
• Perform* checks under first problem
(Number 1)-
4. Incoming and
ni itnninn
volume low.
• Are other phones off hook at same time? If
so this is normal condition as volume
drops when additional phones are used at
once.
5. Tone feedback
flutter when
dialing in Pulse
mode.
• This is normal as power is fluctuating with
phone outpulsing.