GE 49-8255 - Manual (Page 24)

CARE AND CLEANING
(continued)
Oven Vent
The oven is venied through an opening under the right
rear surface unit. Never cover the opening v^ith
aluminum foil or any other material. This would
prevent the oven vent from working properly.
Cooktop Surface Lamp
(on some models)
When changing a cooktop lamp, do not touch the
metal at the ends of the lamps
The cooktop light is easily replaced with a fluorescent
tnhc» comí» t*/Qttíjrrí» /’ViOMfrirnY th#» lanr»«
V/X XI.AW TV JUf'V'XWXW UAW
pull the plug to the range or disconnect the power at
the main fuse or circuit breaker panel.
To remove:
• Lift the Imp cover by pulling the bottom edge
toward you and then up.
® Place fingers on top near each end of the lamp.
• Roll the top of the lamp gently toward the front of
the range and gently pull the lamp from the socket,
making sure it does not hit the lamp cover.
To replace:
® Place fingers on the top near each end of the lamp.
• Press the lamp into the slots until it snaps into place.
• Move lamp cover down and snap into place.
Control Panel and Knobs
Clean up any spills or spatters with a damp cloth.
Remove heavier soil with warm, soapy water.
Clean control panel with mild liquid dish detergent
and a soft cloth. Rub control panel lightly.
CAUTION: Do not use abrasives of any kind on the
control panel. The lettering on models with touch pads
is sensitive to abrasives and pressure.
The control knobs may be removed for easier
cleaning. To remove knob, pull it straight off the stem.
Wash knobs in soap and water but do not soak.
24
Removable Oven Door
To REMOVE door, open to BROIL position, or where
y\^u vaiwii« liuiu uwui ixit ii up
and away from the hinges.
To REPLACE, line up the door with the hinges and
push the door firmly into place.