GE ZSCIO00 - Manual (Page 41)

Troubleshooting
A.(Ivanti um Oven
Questions
?
Use this
problem
solver
Problem Possible Causes What To Do/Explanation
IIGHTS
Light during a
speedcook cycle
dims and cycles on
and off, even at fuH
power levels This is normal.
Power level has been
automatically reduced
because the oven is hot.
• This is normal. The oven senses the
heat level and adjusts automatically.
Light visible around
the door and outer
case while
speedcooking This is normal. • When the oven is on, light may
be visible around the door and
outer case.
FAN
Fan continues to run
after cooking stops The oven is cooling. • The fan will automatically shut off
when the internal parts of the oven
have cooled.
Oven vent emits warm
air while oven is on This is normal.
Fan comes on
automatically when
using the microwave This is normal.
COOKING
The oven makes
unusual sounds
while cooking
Clicks and fans blowing
are normal. The relay
board is turning the
components on and off.
• These sounds are normal.
Smoke comes out
of the oven when
I open the door Food is high in fat
content. Aerosol spray
used on the pans. • Smoke is normal when cooking
high-fat foods.
Food is not fuHy
cooked or browned
at the end of a
cooking program Programmed times
may not match the size
or amount of food you
are cooking.
• Increase
or
decrease time for
doneness or adjust the upper or
lower lamps for browning and
doneness.
SENSOR ERROR
displayed along with
an oven signal Food amount or type
placed in the oven does
not match the program
that was set.
* Press the CT .FAR/OFF pad. Set the
oven program to match the food
or
liquid
to
be cooked or heated.
Steam was not sensed by
the oven because plastic
wrap was not vented, a, lid
too tight was on the di,sh
or a liq uid was covered.
• Vent plastic wrap, use a looser lid
or uncover liquids when cooking or
heating.
41