Cleaning, To remove the burner ports, Acaution – GE ZGU364NRPSS User Manual
Page 14: Dual-flame, Siackea oumers, Stainless steel surfaces, Саге and cleaning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Саге and Cleaning
Professional Rangetops
Dual-flame
The burner consists of three ports: the burner
III
base, burner head and burner cop. The burner
SiaCKea oumers
head and burner cap can be lifted off, making
them easy to clean.
ACAUTION:
DO NOT OPERATE THE
BURNER WITHOUT ALL BURNER PARTS IN PLACE.
Surface burners should be cleaned routinely,
especially after bad spillovers, which could clog
the slots and holes in the burner heads.
The electrode is located at the rear of each
burner. Do not attempt to disassemble or clean
around any burner while another burner is on. An
electric shock may result.
Burner Cap
Burner
Head
Burner Base
Cleaning
Lift off burner parts only when cool. Wash in hot,
soapy water. You may use a plastic scouring pad
to remove burned-on food particles.
To remove burned-on food, soak the burner
heads in a solution of mild liquid detergent and
hot water for 20-30 minutes. For more stubborn
stains, use a plastic scouring pad or toothbrush.
If the spill goes inside the burner head assembly,
wash it under running water and shake to
remove excess water.
After Cleaning
Before replacing the burner parts, shake out
excess water and then dry them thoroughly.
To replace the burner parts:
Make sure that the burner parts are replaced in
the correct location.
1. Replace the burner head on top of the burner
base, making sure that the hole in the burner
head is properly aligned with the electrode
in the burner base. A small gap between the
base and head is normal.
2. Place the burner cap on top of the burner
head. Make sure that the burner cap is
properly seated on the burner head.
To remove the burner ports:
1. Turn all controls OFF before removing any
burner parts.
2. When cool, you may lift off the burner grates,
burner caps and burner heads for easier
cleaning. Do not remove the burner bases.
]
ГГТТГТТТТТ
Burner cap properly seated
тггттт^^
Burner cap not properly seated
Stainless
steel
surfaces
Do not use a steel-wool pad; it will permanently
scratch the surface.
To clean the stainless steel surface, use
warm sudsy water or a stainless steel cleaner.
Always wipe the surface in the direction of the
grain. Follow the cleaner instructions for cleaning
the stainless steel surface.
A bottle of stainless steel cleaner is provided with
the rangetop.
To inquire about purchasing stainless steel
appliance cleaner, please call our toll-free
number, 800.626.2002 or visit monogram.com.
14