Whirlpool ETl8SC - Manual (Page 6)

Adjusting the refrigerator shelves...
1 First, remove food from shelf,
2, Slide shelf straight out to stop,
3 Lift front,
4, Slide the rest of the way out
Guide Stop
Shelf Stop
Replacing Shelf:
1, Fit back of shelf on top of guides with wire stops
on the bottom of guides
2 Lift front, slide shelf in until it clears guide stops
Shelf Guide
Removing the crisper, trivet and
crisper cover...
Removing crisper:
1, Slide crisper straight out to stop,
2, Lift the front,
3, Slide the rest of the way out,
4, Replace in reverse order.
Removing trivet:
1, Lift the trivet from the support brackets on the back
wall,
2, Replace in reverse order
Removing cover:
1, Lift front, then lift back,
2, Pull up and out.
Replacing cover:
1, Fit notches on back of cover into supports on back
wall of refrigerator,
2, Lower front into place.
Changing the light bulb...
WARNING: Before removing the iight buib, either
unpiug the refrigerator or disconnect
the electricity leading to the re­
frigerator at the main power supply.
Shock and injury can occur if eiec-
tricity remains connected.
1, Reach behind control console to find bulb
2 Remove bulb
3, Replace with a 40-watt appliance buib.
Lift the Front, Then the Bock.
Pull Out to Stop.
Lift the Front and Pull Again.
Ice cube trays...
To remove ice:
1, Flold tray at both ends.
2. Slightly twist.
If cubes are not used, they may shrink. The moving
cold air starts a slow evaporation. The longer cubes
are stored, the smaller they get.