Whirlpool LA6400XK - Manual (Page 7)

Liquid Fabric
Softener Dispenser
The dispense
softener fits over thr
The dispenser will h
for liquid fabric
top of the agitator,
eid enough diluted
fabric softener for one deep rinse
• After adding the detergent and the
oad, fit the dispenser over the top of the
agitator cap
• Following directions on the bottle,
add the correct arr-ount of fabric soft­
ener, Use a cup with a pouring spout
to avoid dripping any on the load
• IMPORTANT: Add enough hot or
warm water to fill the dispenser to
the FULL mark.
• Diluted fabric softener will be added
just before the washer starts filling for f he
rinse. NOTE: Do nof stop the washer
during the first spin [when the wash
water is spinning out]. If you do, the fab­
ric softener will be added to the wet,
soapy load. This can cause stains
• Clean the dispenser after each use
with warm water only. Detergent can
make softeners sticky and lumpy.
For a Pre Wash
Use this setting for a shorter SOAK
CYCLE (no rinse]. Use enough detergent
for a single wash. Add the load
• Set the LOAD SIZE SELECTOR.
• Set wash water temperature.
• Push the Cycle Control Knob in and
turn it to the 12-minute mark in the SOAK
CYCLE
22
• "^he washer will fill, agitate fm *w'o
minutes, soak for eight "^in jtes agitate
for two more, and then drain and spin
(See SOAK CYCLE descno+ion on cage
10 ]
• After filling, the washer may pause
before starting to agitate.
For Rinsing Oniy
Your washer can be set to .nnse
only. Use the setting for an extra rmse, or
for laundry that only needs a rinse and
spin
PERMANENT
PRESS
There is a dot just after the num­
bers in PERMANENT PRESS, REGULAR
HEAVY and KNITS GENTLE, If you push in
on the Cycle Control Knob, turn the
pointer to one of those dots and pull the
Control Knob out, the washer wiii fill,
agitate, drain and spin.
If you want high agitation and
spin, use the dot in REGULAR HEAVY, If
you want low agitation and spin, use the
dot in KNITS GENTLE, Use the dot in PER­
MANENT PRESS if you want high
agitation and a low-speed spin
For Spinning Oniy
To set the washer so it drains and
spins water out of the load, push in on
the Control Knob, turn the dial to the
right [clockwise] so the pointer is touch-
ng the bar just before GEE in any cycle
• Pull the Control Knob out to start the
washer.
The washer will drain, spin out
water and stop. If you want a low-speed
spin, use the bar on PERMANENT PRESS
or KNITS GENTLE, All the other cyole
settings have a high-speed spin.