Whirlpool LA6400XK - Manual (Page 10)

SET WATER TEMPERATURE
PUSH IN KNOB, TURN TO
CYCLE AND TIME
PULL OUT TO START
SOAK CYCLE
^hiLs cycle IS not for washing it soaks
ag fates spins out the water and stops
nc r nse I Use it for stained, yellowed,
grey or neaviiy soiled laundn/ with a
cte’ergent or pre-soak product. Chlorine
bleach, 'f w'onted, should be added
to the cycle you use after the SOAK
Cycle IS over
FILL WASH SOAK
To 2 Minutes 8 Minutes
Selecfea B Low m No
level
w Agitation w Agitation
If You Need
Service or Help,
We suggest You
Follow These Three
Steps:
1 Before calling for service ...
ProbierTiS ony so'cetirnes caused
trv iic e Oings V O ; a r . correct without
tools Check this is'be'ore you call for
service
IF YOUR WASHER DOES NOT FILL:
• Is tne power supp v cord plugged IrC
• Are both water faucets openh
•
• IS a tuse blown
trippedc ilrcult-breaker
• Are the water supply hoses kinked?
• Is the Cycle Control Knob set and
pulled out?
• Are the water inlet hose filter screens
clean?
To check the screens:
- Turn off the faucets,
- Remove hoses and check the
screens
- Clean the screens under running
water,
- Replace the hoses and tighten
connections,
- Turn on the faucets and check
the leaks
IF YOUR WASHER DOES NOT SPIN:
• Is the lid closed?
• Is the power supply cord plugged in?
• Is a fuse blown or circuit-breaker
tripped?
IF WASHER FILLS AND DRAINS WITHOUT
RUNNING:
• Make sure that the Cycle Control
Knob is pointing to a number in the cycle,
IF YOUR WASHER STOPS DURING THE
PERMANENT PRESS CYCLE.
• Remember, the washer will stop for
about IV
2 minutes after the partial drain
during the cool-down period in this
cycle,
MAKE SURE THE DRAIN HOSE IS HIGHER
THAN THE WATER LEVEL IN THE WASHER.
IF IT ISN'T...
• The washer may seem to be draining
during wash and rinse cycles,
• Water can siphon out, (See Installation
Instructions,!
10