Whirlpool CHCH8WS - Manual (Page 5)

INSTALL LOOSE PARTS
REAR MOUNTING
PIN
BIN CONTROL
SPRING
FRONT MOUNTING
BOLT
FLEX CUBE
DEFLECTOR
OVER PINS
The following loose parts packed inside the head will have
to be field installed.
1. Water Pump Pan. Hold pan so the gradually sloped
area is at left. Place the left lip edge between the lower
evaporator and on the top of the entering edge of the
lower cutter grid Raise right end of water pan and place
pan flange on angle bracket attached to right liner wall
Remove packing holding the float valve for shipping
2. Drain Line tor Water Pump Pan. The formed piece of
white vinyl tubing slips over the pump pan drain tube
and the dram tube going through the back wall of the
storage bin or on a field constructed bin run to an open
drain.
NOTE: The1/8"dia siphon break hole must be in ttie
vertical leg of white vinyl tubihg
CAUTION: Insufficient or continuous siphoning may
result from:
a. Reducing the inside diameter of the drain line.
b. Having less than 1/4" per foot fall.
c. Traps or extreme bends in the lines.
3. Cube Deflector. Flex cube deflector baffle so that it
hangs from pins. Top edge will rest against cutter grid
frame.
4. Ice Level Control Baffle. The ice level baffle must be
installed at the bottom left end of the ice maker head with
the curve inward. Slip the hole in the baffle over the pin in
the back liner wall. Raise up front edge and fasten through
lower support rail by removing and reinserting screw pro­
vided. Install spring from baffle to right hand hole in lower
support rail to hold baffle off switch plunger. Weight of ice
against baffle will operate switch.
NOTE: Baffle must swing freely without binding.
5. Let Baffle Hang Vertically. Move baffle slowly to left
and listen for bin switch "click" to determine that switch
will turn machine "ON" and "OFF." (Adjust switch tab
until switch operates.)