For the electrician, Conform to all applicable codes, Install grounding wire – Whirlpool CHCH8WS User Manual
Page 3: Jumper wire, Metal, Water, Pipe, N0.4 copper wire, Minimum, Grounded metal cold water pipe
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FOR THE ELECTRICIAN
CONFORM TO ALL APPLICABLE CODES
It IS the personal responsibility and obligation of the
customer to contact a qualified installer to assure that the
electrical installation is adequate and is in conformance
with the National Electrical Code and local codes and
ordinances
NOTE: A separate circuit must be used with 20 ampere
time delay fuses.
REMOVE TOP SHROUD
1. Loosen screws on lower front corners of shroud.
2. Pull complete shroud forward and lift off.
Use proper care when handling this awkward
CAUTION:
part.
INSTALL GROUNDING WIRE
COPPER WIRE ONLY
1
.
Permanently ground this ice maker in accordance
with the National Electrical Code and local codes and
ordinances GROUND MUST BE CONTINUOUS
2.
Use a copper conductor of the appropriate size
from the ice maker green grounding wire to a grounded
connection in the service panel or a properly driven and
electrically grounded rod.
3. Replace electrical junction box cover
4. Replace shroud.
Alternate (Not Recommended)
1.
If the recommended grounding method is impossible,
permanently ground the appliance from the green ground
ing screw to a grounded cold water pipe*using a separate,
green colored, insulated copper conductor of appropriate
size, THIS, HOWEVER IS NOT RECOMMENDED.
NOTE: Do not ground to a gas supply pipe Do not con
nect to electric power supply until appliance is perma
nently grounded
JUMPER WIRE
METAL
WATER
PIPE
CLAMP
N0.4 COPPER
WIRE
MINIMUM^
GROUNDED
METAL COLD
WATER PIPE
CR-119
INSTALL ELECTRICAL WIRING
COPPER WIRE ONLY
115-208/230 V, 3-Wire, 60 Hz, 1 Ph,
20 Amp Time Delay Fuses
Install wiring according to Local and National Electrical
Codes into junction box provided at rear of cabinet. Replace
electrical box cover and shroud.
PROVIDE A FUSED DISCONNECT BOX WITHIN
SIGHT AND EASY REACH OF THE ICE MAKER.
Be sure power supply is within + 10% - 5% of recommended
voltage when machine is in operation.
TO SERVICE
PANEL
ICE MAKER
ELECTRICAL
JUNCTION BOX
PERMANENT AND
CONTINUOUS
GROUND (GREEN)
DISCONNECT
BOX
20 AMP TIME
DELAY FUSES
RIGID OR
FLEXIBLE
CONDUIT
Cold water pipe must have metal continuity to electrical ground and
not be interrupted by plastic, rubber or other electrically insulating
connectors (including water meter or pumpi without adding a copper
jumper wire at these connections.