Removing the crisper, meat drawer and covers, Adjusting meat drawer temperature, Removing freezer bin – Whirlpool ED20AK User Manual
Page 6: Adjusting the refrigerator shelves
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Adjusting the refrigerator shelves...
Shelves can be adjusted to match the way you
To remove shelves:
1. Tilt up at front.
2.
Lift up at back.
3.
Pull shelt straight out.
To replace shelves:
1. Guide the rear hooks into the slots in the shelf
supports.
2.
Tilt up front of shelf until hooks drop into slot.
Lower front of shelf to level position.
Removing the crisper, meat drawer and covers
.-J,.
To remove the crisper and meat drawer:
1. Slide crisper and meatdrawerstraightouttothe
stop, lift drawer, then slide the rest of the way out.
2.
Replace in reverse order.
To remove the covers:
1. Push up crisper cover glass insert from bottom,
then slide out with both hands.
2.
Lift front of cover frame.
3.
Lift out cover frame by pulling up and out.
4.
Repeat for meat drawer cover.
To replace the covers:
1. Fit back of meat drawer cover in notch supports
on walls of refrigerator, then lower into place
2.
Repeat for crisper cover frame.
3.
Slide back of crisper cover glass insert into
place, then lower front.
PULL OUT TO THE STOP,
LIFT THE FRONT
AND PULL AGAIN.
REMOVE THE
GLASS INSERT,
LIFT THE FRAME FRONT,
THEN THE BACK.
Adjusting meat drawer temperature...
t
i
USE CONTROL TO ADJUST
MEAT DRAWER TEMPERATURE
Cold air tiows against the meat drawer through
an opening between the freezer and the refrigera
tor. This helps keep the meat drawer colder than
the rest of the refrigerator.
Slide the control to let more or less cold air
thraugh.
Removing freezer bin...
For proper air movement, keep the freezer bin
in place when the refrigerator is operating.
To remove the bin:
1. Slide bin out to the stop.
2.
Lift the front to clear the stop.
3.
Slide out the rest of the way.
To replace the bln:
1. Place bin on the slides.
2.
Make sure the stops olear the front of the
slides.
3.
Slide bin in