Before using your refrigerator, Remove sales labels, Clean it – Whirlpool ED20AK User Manual
Page 4: Install properly, Plug it in, Level refrigerator-freezer
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before using your
refrigerator
1. Remove sales labels...
Remove the Consumer Buy Guide Label, tape
and any inside labels before using the refrigera
tor To remove any remaining glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing de
tergent before removing glue as described in
step 1.
DO NOT USE sharp instruments, rubbing alco
hol, flammable fluids or abrasive cleaners.
These can damage the material. See “Impor
tant Safety Instructions’’ on page 3.
NOTE; DO NOT REMOVE ANY PERMANENT IN
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
2. Clean it...
Clean your refrigerator before using it. See
cleaning instructions on page 9.
4. Install properly...
3. Plug it in...
RECOMMENDED GROUNDING METHOD
A115 Volt, 60 Hz,, AC only 15 or 20 ampere fused
and properly grounded electrical supply is re
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recepta
cle which cannot be turned off with a switch or
pull chain. See Electrical Requirements and
Grounding Instruction Sheet in your Literature
Package.
1. Allow
'/2
inch (1.25 cm) space on each side and
at the top of the refrigerator for ease of
installation.
2. If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side closest to the wall so the door can be
opened wider.
3. The refrigerator back can be flush against the
wall.
5. Level refrigerator-freezer...
1. Remove base grille. (See page 8.)
2. To raise front, turn screw in direction shown,
3. To lower front, turn screw in direction shown.
4. Check with level.
5. Replace base grille. (See page 8.)