Whirlpool FGP335B - Manual (Page 24)

I F Y O U N E E D A S S I S T A N C E O R S E R V I C E
PROBLEM POSSIBLE CAUSE SOLUTION
Burner flames
lift off ports, are
yellow, or are
noisy when
turned off
Air/gas mixture is incorrect. Contact an authorized Roper
service technician to check air/gas
mixture.
Burner makes Burner is wet from washing. Let dry.
popping noise
when on
Control knob(s)
will not turn You are not pushing in before
turning. Push control knob(s) in before turning
to a setting.
Cooking results
are not what The range is not level. Level range. (See Installation
Instructions.)
you expected
The oven temperature seems
too low or too high. Adjust the oven temperature control.
(See “Adjusting the oven temperature
control” on page 13.)
The oven was not preheated
as the recipe calls for. Preheat oven if called for in recipe.
The recipe has never been
tested or is not from a reliable Use only tested recipes from a reliable
source.
source.
The pans are not the type or
size recommended in the Refer to a reliable cookbook for recom­
mended pan type and size.
recipe.
There is not proper air circu­
lation around pan when
baking.
Allow 1V 2 to 2 inches (4-5 cm) on all
sides of the pans for air circulation.
There must be a minimum space of
1 inch (2.5 cm).
Flame size does not fit the
cooking utensil being used.
Adjust flame size to fit cooking utensil.
When broiling, you have not
completely closed the broiler
drawer. Completely close broiler drawer.
24