Before putting the burners back, dry, Removing the oven door, Burn and electrical shock hazard – Whirlpool FGP335B User Manual

Page 18: To remove, To replace

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

C A R I N G F O R Y O U R R A N G E

4. If ports are clogged, clean with a straight

pin. DO NOT enlarge or distort the ports.
DO NOT use a toothpick to clean the ports.

5. Before putting the burners back, dry

them thoroughly by setting them in a
warm oven for 30 minutes.

6. Replace

burners, making sure they are

properly seated and level.

Replace

screws.

7. Occasionally check

the burner flames

for proper size and shape as shown. A

good flame is blue in color. If flames lift
off ports, are yellow, or are noisy when

turned off, you may need to clean the
burners (see above), or call a qualified
technician for adjustment.

Ports

Typical surface burner flame

at highest setting

Removing the oven door

Removing the oven door will help make it

easier to clean the oven.

^WARNING

Burn and Electrical Shock Hazard

Make sure all controls are OFF and the
oven is cool before removing oven

door.

Failure to do so could result in burns or

electrical shock.

To remove:

1. Open

the door as far as it will go.

2. Remove

the screws on each side of the

oven door.

3. Close

the door about % of the way.

Lift

the door up and off the hinges.

To replace:

Be sure

the hinge arms are in the open

position.

Be careful

if pulling the hinges

open by hand. Hinges may snap back
against the oven frame and could pinch
fingers.

Screw