Whirlpool FGP335B - Manual (Page 17)

C A R I N G F O R Y O U R R A N G E
Lift-up cooktop
1. Remove surface burner grates.
2. Lift front of cooktop at both front corners until
the support rods lock into place.
^WARNING
Personal Injury Hazard
Be sure both support rods are fully
extended and in the locked position.
Failure to do so could result in per­
sonal injury from the cooktop acciden­
tally falling.
Product Damage Hazard
Do not drop the cooktop.
Damage could result to the porcelain
and the cooktop frame.
3. Wipe with warm, soapy water. Use a soapy
steel-wool pad on heavily soiled areas.
4. To lower the cooktop, lift cooktop from both
sides while pressing the support rods back to
unlock them. Lower the cooktop into place.
Replace surface burner grates.
Surface burners
1. Lift up the cooktop, following the instructions
above.
2. Before cleaning, remove screws that
hold each of the burners in place. The
screws prevent the burners from moving
during shipment. Remove the shipping
screw with a Phillips screwdriver, lift the
burner up, tilt it to one side at the end
closest to the ignitor and move it toward
the back of the range. This separates the
burner from the gas valve at the front of
the range, so it can be easily removed.
3. Wipe off surface burners with warm, soapy
water and a sponge after each use. To
remove cooked-on food, soak the burners
in a vinegar and water solution for 20-30
minutes.
Scrub with a plastic scrubbing pad.
17