Whirlpool UPRIGHT FREEZER - Manual (Page 24)

Attaching the ice maker to a water supply
(on some models)
Read all directions carefully before you begin.
^WARNING
Electrical Shock Hazard
Unplug the refrigerator before
installing ice maker.
Failure to do so can result in death
or electrical shock.
IMPORTANT:
• Use copper tubing only and check for leaks.
• Install ice maker tubing in areas where
temperatures are above freezing.
Tools required:
• standard screwdriver
• yi6-inch and Va-inch open-end wrenches
or two adjustable wrenches
• V4-inch nut driver
• V4-inch drill bit
• Hand drill or electric drill (properly grounded)
NOTE: Your appliance dealer has a kit
available with a V4-inch saddle type shut-off
valve, a union, and copper tubing. Before
purchasing, make sure a saddle type valve
complies with your local plumbing codes.
Do not use piercing type or Yie-inch saddle
valve which reduces water flow and clogs
more easily.
Cold water supply
The ice maker water valve contains a flow
washer which is used as a water pressure
regulator. The ice maker needs to be
connected to a cold water line with water
pressure limitations of 20-120 psi. If a
problem occurs, call your utility company.
IMPORTANT:
• It may take up to 24 hours for your ice
maker to begin producing ice.
• If operating the refrigerator before install­
ing the water connection, turn ice maker
to the OFF position to prevent operation
without water.
• All installations must be in accordance
with local plumbing code requirements.
INSTALLATION IS NOT WARRANTED
BY REFRIGERATOR OR ICE MAKER
MANUFACTURER.
23