Whirlpool ET20EK - Manual (Page 4)

1. Allow V 2 inch (1.25 cm) space on each side and
at the top of the refrigerator for ease of
installation.
2. If the refrigerator is to be against a wali, you
might want to leave extra space so the door
can be opened wider.
3. The refrigerator back can be flush against the
wali.
Level refrigerator-freezer...
1. Remove base griiie (see page 7).
2. To raise front, turn screw in direction shown.
3. To iower front, turn screw in the direction shown.
4. Check with level.
Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any inside labels before using the re­
frigerator. To remove any remaining glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with iiquid hand dishwashing
detergent before removing giue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car­
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN­
STRUCTIONS LABELS INSIDE YOUR REFRIGER­
ATOR.
Do not remove the Tech sheet fastened under
the refrigerator at the front.
Clean it...
Ciean your refriger
ator before using it.
See cleaning instruc
tions on page 9.
Plug it in...
3-PRONG GROUNDING
TYPE WALL RECEPTACLE
REFRIGERATOR
POWER CORD
3-PRONG
GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
required. It is recommended that a separate cir­
cuit serving oniy this appliance be provided.
Do not use an extension cord. Use a recepta­
cle which cannot be turned off with a switch or
pull chain. See individual electrical requirements
and grounding instruction sheet in your literature
package.