Whirlpool EV20VS - Manual (Page 7)

Bottom basket.. Changing light bulb...
To remove:
• Lift up, then pull out.
To replace:
• Insert into rear slides
• Lower into place.
• Push basket into freezer.
1. Unpl.jg power cord.
2. Rem:)ve light shield by pulling away from the
side wall.
3. RepI :зсе bulb with 40 watt appliance bulb.
4. To replace shield, insert tabs into slots in wall
and press.
5. Plug power cord Into outlet.
Cleaning your freezer
This freezer should be cleaned when frost has
built up to about % inch (6 mm) thickness. Com­
plete defrosting and cleaning should be done at
least once a year. In high humidity areas, a freezer
may need more frequent defrosting.
To defrost and clean;
1. Turn Cold Control to OFF.
2. Unplug power cord.
3. Take out all food and removable parts.
Note: Wrap frozen foods and packages In sev­
eral layers of newspaper and cover with a blan­
ket. Food will stay frozen several hours.
4. Place pans of hot water inside freezer to speed
melting of frost. Keep door open. Ice can be
removed in large pieces as it melts.
Direct air from electric fan into freezer to speed
defrosting.
5. Remove base grille, see page 7.
6. Unclip hose and allow water to drain through
hose into a flat pan.
7. Cleon freezer according to the following
direi :;tions.
After defrosting:
1. Hool drain hose in place.
2. RepI ::ce base grille.
3. Plug in power cord.
4. See :jirections for "Setting the Cold Control,"
pagi;; 5.
Removing the base grille...
-Metal Clips
Support Tabs
3. Do not remove Tech sheet fastened behind grille
Metal Clips
Support Tabs
To replace:
1, Line US) grille support tabs with metai clips,
2, Push f -mly to snap into place,
3, Close Ihe door
7