Whirlpool EV20VS - Manual (Page 4)

Install properly...
Check the strength of the floor. It should hold
the weight of fully loaded freezer.
Pick a safe place, indoors, away from in­
flammables such as gasoline.
Allow Vz" (.2 cm) space on each side and at
top for ease of installation.
Level freezer...
so that door wiii stay open at any position,
1. Remove base grille (see page 7).
Leveling Leg
Lower
2. To raise front, turn each leg to the left.
3. To lower front, turn each leg to the right.
4. Cheek with level.
5. After freezer is fully loaded, recheck with level.
Remove sales labels...
Remove the Consumer Buy Guide label and
any inside labels before using the freezer. Re­
move a "ly left over glue with rubbing aloohol.
NOTE: DO NOT REMOVE the label just
above the Temperature Alarm Switch or
the Tech Sheet fastened behind the base
grille
Clean it.
Clean your freezer before using it. See clean­
ing i istructions on page 7.
Install the battery...
You \A II find the freezer key and a 9-volt al­
kaline flattery packed inside the freezer. Install
the battery by following instructions on page 6.
The Temperature Alarm will sound a continu­
ous tone itthe Temperature Alarm Switch is in the
ON or Ti; ST position. Move the switch to OFF until
the free :er is cold. Then move it to ON.
Plug it in...
3-| irong grounding
type wall receptacle
3-prong
grounding plug
Freezer
power cord
R ECOMMENDED GROUNDING METHOD
A 115 ,/olt, 60 Hz,, AC only 15 or 20 ampere fused
and pre perly grounded electrical supply is re­
quired, ■ is recommended that a separate circuit
serving < mly this appliance be provided
Do ne t use an extension cord. Use a recep­
tacle which cannot be turned off with a switch
or pull chain. See individual electrical require­
ments a'd grounding instruction sheet in your liter­
ature package