Install properly, Remove sales labels, Clean it – Whirlpool EV110E User Manual

Page 4: Plug it in, Level freezer

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Install properly...

1, Check the strength of the floor. It should hold the

weight of a fully loaded freezer.

2 Pick a safe place, indoors, away from in

flammables such as gasoline.

3. Allow 3 Inches (7.5 cm) air space on top of freezer

for proper ventilation.

4. Allow at least an Inch (2.5 cm) between the

freezer condenser, on the back of the unit, and
the wall.

5. Allow

'/2

Inch (1,25 cm) on each side of the freezer

for ease of installation.

6. If the freezer is to be against a wall, you might

want to leave extra space on the hinge side so the
door can be opened wider.

Level freezer...

so the door will stay

Sfart adjustment with the door hinge side.

1. Slide freezer into place.

2. Adjust front legs to level the freezer,

-To raise front, turn each leg clockwise.
-To lower front, turn each leg counter-clockwise,

3. Check with level.
4. After freezer is fully loaded, recheck with level.

Remove sales labels...

Remove the Consumer Buy Guide label and any

inside

labels before using the freezer.

To remove any remaining glue:

1, Rub briskly with thumb to make a ball, then

remove.

2, Soak area with dishwashing detergent solution (1

teaspoon detergent in 1 quart warm water) be
fore removing glue as described in step 1

DO NOT USE rubbing aloohol or flammable or

toxio solvents, suoh as aoetone, gasoline, oar-

bon tetraohloride, eto. These oan damage the
material.

NOTE: DO NOT REMOVE the Teoh Sheet fas

tened under the freezer at the front.

Clean it...

Clean your freezer before

using it. See cleaning
instructions on page 6.

Plug it in...

3-prong grounding

type wall receptacle

Freezer

Power Plug

3-prong

grounding plug

Recommended Grounding Method

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused

and properly grounded electrical supply is required.
It Is recommended that a separate circuit serving only
this appliance be provided.

Use a receptacle

which cannot be turned off with a switch or pull
chain. Do not use an extension cord.

Attach retaining clip over power cord plug from

literature package inside the freezer