Operating models ad025, ado30, ado40 and ado50, Control panel, Unit operation – Whirlpool ADO15 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USING YOUR DEHUMIDIFIER
Operating models AD025, ADO30, ADO40
and ADO50
Control panel
These units have a control panel containing two
controls-the PAN FULL Light and the Humidistat.
PAN FULL Light-This light glows when the
water pan is full and needs to be emptied.
Humidistat-This controls the amount of moisture
in the room. When the humidity in the room rises
above the setting, the unit automatically starts.
When the humidity drops below the setting, the
unit automatically stops. The unit will run
constantly when the control is set to DRYEST.
Unit operation:
1. Turn the Humidistat to OFF. Plug the power
supply cord into an electrical outlet. Be sure to
use the proper grounding method. (See
page 6.)
2. Turn the Humidistat toward DRYEST for
normal operation.
The Humidistat can be set anywhere
between OFF and DRYEST. If you need more
dehumidification, turn the Humidistat toward
DRYEST. If you need less dehumidification,
turn the Humidistat toward OFF.
3. Turn the Humidistat to OFF to stop the unit
manually.