Caring for your pehumipifier – Whirlpool ADO15 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CARING FOR YOUR PEHUMIPIFIER
5. For models AD025, ADO30, ADO40 and
ADO50: Remove the rear grille by pulling out
at bottom and dropping grille down.
6. Lift cabinet off un'it base.
7. Brush coils clean, if necessary, with warm
water and a mild detergent. Rinse and dry
thoroughly. Be sure the power supply cord
is disconnected from the electrical outlet
NOTE: The compressor is sealed and needs
no oiling. The fan motor is prelubricated and
does not require further oiling under normal
operating conditions. However, if the
dehumidifier is operated under severe
environmental conditions (dust, dirt, high
temperatures) the fan motor should be oiled
annually. Follow the instructions in step 8.
Coils
8. Oil the fan motor through the tubes provided.
An easy-to-use capsule of especially
recommended oil (Part No. 10943) is
available from your nearest authorized
Whirlpool®“ service company, or use SAE
#20 non-detergent oil.
Fan motor
oil tubes
9. Wash all plastic parts with a soft cloth, warm
water and a mild detergent. Rinse and dry
them with a soft cloth.
10. Replace cabinet and grille(s).
11. Reconnect dehumidifier to power supply.
13