Whirlpool WHES40 - Manual (Page 3)

Water Softener Safety
Your safety and the safety of others are very important.
We have provided many important safety messages in this manuai and on your appliance. Always read and obey all
safety messages.
This is the safety alert symbol.
This symboi alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or
“WARNING." These words mean:
ADAHGER
AWARNING
You can be killed or seriously Injured If you don't
Immediately follow Instructions.
You can be killed or seriously injured if you don't
follow instructions.
All safety messages will tell you what the potential hazard is^ tell you how to reduce the chance of injury, and tell you
what can happen if the instructions are not followed.
For installations in the Commonwealth of Massachusetts:
Installation by a licensed plumber is required. Plumbing code 248-CMR of the Commonwealth
of Massachusetts must be used for installation.
For installations in the state of California:
You must turn the Salt Efficiency Feature setting to ON. This may initiate more frequent re­
charges, however, it will operate at 4,()()() grains per pound of salt or higher. To turn on the Salt
Efficiency Feature, follow the instructions in the “Salt Efficiency” section of this manual.
Before You Start
See “Location Requirements” section before installing water softener.
Follow the installation instructions carefully. (Failure to install the water softener properly voids the
warranty.)
Before you begin installation, read this entire manual. Then, obtain all the materials and tools you will
need to make the installation.
Check local plumbing and electrical codes.
Use only lead-free solder and flux for all sweat-solder connections, as required by federal codes.
Use care when handling the water softener. Do not turn upside down, drop, or set on sharp protrusions.
Avoid installing in direct sunlight. Excessive sun heat may cause distortion or other damage to
non-metallic parts.
The water softener requires a minimum water flow of 3 gallons per minute at the inlet. Maximum
allowable inlet water pressure is 125 psi. If daytime pressure is over 80 psi, nighttime pressure may
exceed the maximum. Use a pressure reducing valve if necessary. (Adding a pressure reducing valve
may reduce the flow.) If your home is equipped with a back flow preventer, an expansion tank must
be installed in accordance with local codes and laws.
The water softener works on 24 volt-60 hz electrical power only, supplied by a direct plug-in
transformer (included). Be sure to use the included transformer and plug it into a nominal 120V, 60
cycle household outlet that is properly protected by an ovcrcurrent device such as a circuit breaker or
fuse. If transformer is replaced, use only the authorized service, Class II, 24V lOVA transformer.
This system is not intended to be used for treating water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.