Clean / clear water iron removal, Clean feature minutes – Whirlpool WHES40 User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Clean / Clear Water Iron Removal

This feature is beneficial on water supplies containing iron and/or high amounts of sediments (sand,

silt, dirt, etc.). Default setting is “OFF”. When set to “ON”, an additional backwash and fast rinse cycle

will occur first, preceeding the normal regeneration sequence. This provides extra cleaning of the resin

bed before it is regenerated with the salt brine. To conserve water set this feature “OFF” if your water

supply does not contain iron or sediments.

1. Press and hold the PROGRAM button until the following screen is displayed.

Once in this display, press the Q PROGRAM button twice and one of the following two displays

is shown. Both displays will show the word “( dleaif

n c c

u n

uri

CIm

2. Press the

Clean Feature Minutes

L_i Up or

Down buttons to set On or Off.

To adjust the length of the Clean/Clear Water Iron Removal feature, from 1 to 15 minutes in length.

To change this cycle time, use the UP button to increase the time, or the DOWN button to shorten the

time. If you are using this feature the length of the extra backwash cycle automatically sets to 9 minutes.

1. Press and hold the PROGRAM button until the following screen is displayed.

Once in this display, press the PROGRAM button three times and following display is shown.

2. Press the

Up or

Down buttons to set number of minutes.