Set time of day, Program the water softener, Uco™ 1 (ou – Whirlpool WHES40 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Program the Water Softener
SET SALT LEVEL button
Display
UP button
Figure 10
If you have questions about installation, programming, operating and routine maintenance...
call 1-866-986-3223, Monday - Friday, 8 am to 9 pm, EST.
When the water softener is plugged in, a model code and a test number (example: Jl.O), begin to flash
in the faceplate display. Then, “12:00 PM” and the words “CURRENT TIME” begin to flash.
NOTE:
If--------shows in the display, press the UP ^^ or DOWN V until LE40 shows
in the display. Then, press the PROGRAM button to set, and change to the
flashing “CURRENT TIME” display.
Set Time of Day
If the words “CURRENT TIME” do not show in the display, press the PROGRAM button until
they do.
1. Press the C-d Up or v Down buttons to set the present time. Up sets the display ahead; down
sets the time back.
UCO™
1
(OU
1 hJU
Current
r/me
Time
Be sure AM or PM is correct.
NOTE:
Press buttons and quickly release to slowly advance the display. Hold the buttons
down for fast advance. This procedure applies for all following settings.
16