Whirlpool WHES40 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

2. Check the brine tank and brinewcll (black tube in salt storage tank) monthly. If hardening is

present, pour small amounts of warm water on hardened areas until they loosen;

3. Be sure to set the correct salt type depending on which salt type is used (NaCl or KCl).

Use the Up or Down buttons to toggle between NaCl or KCl and press the

PROGRAM button to enter information.

4. Press the (^) PROGRAM button once again to return to normal operating display.

Start a Recharge

Press the RECHARGE button and hold for three seconds until Recharge begins to flash in the timer

display, starting a recharge. This recharge draws the sanitizing bleach into and through the water

softener. Any air remaining in the water softener is purged to the drain.

If you have questions about installation, programming, operating and routine maintenance...

call f-866-986-3223, Monday - Friday, 8 am to 9 pm, EST.