Removing the drop-in door trim pieces, Pi ip, Changing the control settings – Whirlpool RT16VK User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

U S I N G Y O U R R E F R I G E R A T O R
Changing the control settings
If you need to adjust temperatures in the
refrigerator or freezer, use the settings listed
in the chart below as a guide. If you have
questions, call our Consumer Assistance
Center number. (See page 23.)
• Adjust the Refrigerator Control first.
• Wait at least 24 hours between adjust
ments.
• Then adjust the Freezer Control if needed.
CONDITION:
REASON:
RECOMMENDED
CONTROL SETTINGS:
Refrigerator
Freezer
Refrigerator
* Door opened often
section
* Large amount of food added
too warm
• Room temperature too warm
Freezer
section
too warm
• Door opened often
• Large amount of food added
• Very cold room temperature
(can’t cycle often enough)
6
'
Refrigerator
section
too coid
• Controls not set correctly for
your conditions
0
'
Ice not
made fast
enough
' Heavy ice usage
' Very cold room temperature
(can’t cycle often enough)
pi ip
Q s coom 5 ^
Both sections
too warm
• Door opened often
• Large amount of food added
• Very warm or very cold room
temperatures
^ s
COOUB
s ^
Removing the drop-in door trim pieces
To remove the trim piece:
1. Remove all items from the shelf.
2. Pull straight up on the trim piece at each
end.
To replace the trim piece:
1. Locate each end of the trim piece above
the trim pocket opening.
2. Push the trim piece straight down until it
stops.
3. Replace items on the shelf.