Whirlpool RT16VK - Manual (Page 12)

U S I N G Y O U R R E F R I G E R A T O R
Adjusting the crisper cover track
Because your crispers are not the same
size, your crisper cover he№ an adjustable
center track so you can switch positions of
the crispers.
To remove the center track:
1. Push up the cover insert from the bottom,
then slide out with both hands.
2. Gently pull up on front end of the center
track.
3. Pull rear end of track out of opening in
cover.
To replace the center track:
1. Insert rear end of track (with hole) into
opening in cover.
2. Lower front end of track into slot.
3. Make sure rear end of track has snapped
into place on under side of cover.
Using the ice cube trays
If cubes are not used, they may shrink. The
moving cold air starts a slow evaporation.
The longer you store cubes, the smaller they
get.
To remove ice:
1. Hold tray at both ends.
2. Twist slightly.
Using the optional automatic ice maker
If your refrigerator has an automatic ice
maker, or if you plan to add one later, here
are a few things you will want to Imow.
• The ON/OFF lever is a wire signal arm.
DOWN to make ice automatically
UP to shut off the ice maker
IMPORTANT: Do not turn on the ice
maker until it is connected to the water
supply. Instructions for ice maker water
supply hook up are attached to the
back of the refrigerator cabinet.
UP
to stop
ice maker.
DOWN
to start
ice maker.
12