Whirlpool EV190F - Manual (Page 6)

Removing the bottom basket...
To remove:
1. Lift front of basket up to remove from wall supports.
2, Pull out.
To replace:
1. Position basket in bottom of freezer.
2. Insert basket into wall supports one side at a time.
The key eject lock...
can help
entrapment
reduce the hazard of child To lock or unlock the freezer you must hold the
key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock
If the key is lost, contact your WHIRLPOOL
dealer for a replacement. Always give the com­
plete model and serial number of your freezer
when requesting a replacement key.
The signal light...
automatically warns of any unexpected
power failure.
Signal Light
If the signal light is not glowing,
immediately check:
• for power interruption,
• the power cord; it may be disconnected from
the outlet,
• the signal light; it may be burned out.
To replace burned out signal light:
1. Unplug power cord from outlet.
2. Open the freezer door,
3. Push out signal light from behind, then unplug
burned out light. Repiace light with one of
the same wattage and size. Signal light can
be ordered from your WHIRLPOOL dealer.
Part No. 1103639.
4. Close freezer door and plug power cord into
outlet.
Energy saving tips...
You can help your freezer use less electricity,
• Check door gasket and level freezer to assure a
good door seal,
• Clean the condenser coils regularly,
• Keep door openings to a minimum. Remove several
items at one time. Keep contents organized to elimi­
nate searching.
• Fill to capacity. Follow recommended procedures
for freezing foods. See pages 8 and 9.
• Set Temperature Control to provide temperatures
around 0°F (-17.8 °C], There is no need to store
foods below 0°F,
• Keep door locked to ensure door closure.
• Do not let frost build up to more than TL inch [6 mm)
thick. Efficiency is reduced
• Keep Power Saving Control on OFF when humidity is
low.