Figure 7 – Whirlpool ACE094XM0 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Remove poly-foam block by pushing at top
until bottom can be grasped with hand to
pull from cabinet (see Figure 4). Be careful
not to damage cabinet insulation.
Install plastic drain-cup spout (on cabinets
with side louvers only) into hole at rear of
cabinet. (See Figure 4.) Spout should be
facing downward through hole.
Figure 4
8
4
EMSCkBSEO
STOPS
t
PLASTIC
DfMkOI*CUP
SPCHfr
t
'USED ON
CAttlMns
WitHSlOE
LOUVERS ONLY.
w
l
:
o
:]
POLY-FOAM BLOCK
—
1
I-------------------
1
1
I
1
1
t
1-----
I
1
1
1
1
J ——.
/
—^ SIDE INSULATION
1
1
1
111
6
.
7
.
MNCL
6CAEWS
CABINET VlE
«№0 FROM TOt>
(ROOM S)OE)
Remove paper backing from 3 seal strips and
attach them to the top flange as well as to the
right and left side of unit (see Figure 5).
Install unit into cabinet. First, check tubing.
Realign tubing if it is rubbing adjacent tubes
or extending outside the flange of base unit.
Now slide unit into cabinet until it rests against
rear embossed stops (see Figure 4). Be careful
not to push against sharp fins and plastic parts.
• Ground unit to cabinet by using green ground
wire attached to left-front corner of unit base
and in lower left-hand corner of cabinet.
Fasten wire securely to cabinet using hex
head screw and nut (see Figure 6).
10
.
11
If necessary, drill 3/16" diameter hole in
cabinet for ground wire (see Figure 7). Place
remaining length of wire under front lip of
base behind plastic front panel.
CAUTION:
KEEP WIRE CONNECTED WHEN
EVER
AIR
CONDITIONER
IS
IN
CABINET.
IT
IS
THERE
FOR
YOUR
ELECTRICAL
SAFETY
DURING
OPERATION
AND MAINTENANCE.
Remove
protective
wrapping
from
control
panel. Place control panel in position and
insert control knobs through holes in control
panel and onto control shafts (see Figure 7).
Attach front panel by placing bottom edge on
clips and pushing top down, then in and up.
Figure 7
EXHAUST
CONTROL
NOT
AVAILABLE
ON
ACE864
AND
ACW864
3/4'
3/16” 01A.
HOLE
BASE CUP
IF№CSSAnY, USE
mJLL-HANDLE TO SLID
UNIT OUT OTCMimET.