Receptacle wiring, Recommended grounding method, Electrical – Whirlpool ACE094XM0 User Manual
Page 5: Requirements, Electrical requirements, Chart-c
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RECEPTACLE WIRING
RECEPTACLE WIRING should be at least as
large as size shown on electrical Chart B. Use
copper wire only. It is the personal responsibility
and obligation of the customer to provide
proper and adequate receptacle wiring installed
by a qualified electrician. OBSERVE NATIONAL
ELECTRICAL
CODE
AND
ALL
LOCAL
GOVERNING CODES AND ORDINANCES.
RECOMMENDED GROUNDING METHOD
For your personal safety, this appliance must be
grounded. This appliance is equipped with a
power supply cord having a 3-prong grounding
plug. To minimize possible shock hazard, the
cord must be plugged into a mating 3-prong
grounding type wall receptacle, grounded in
accordance with the National Electrical Code
and local codes and ordinances. If a mating wall
receptacle is not available, it is the personal
responsibility and obligation of the customer to
have a properly grounded 3-prong wall receptacle
installed by a qualified electrician.
ELECTRICAL
REQUIREMENTS
For 230 volt and 230/208 volt models with
serial plate amperes up through 16.0
Refer to Chart C for specific wiring and receptacle
information to be used.
OBSERVE
ALL
LOCAL
GOVERNING
CODES
AND ORDINANCES
Do not, under any circumstances, remove the
power supply cord ground prong.
ELECTRICAL GROUND IS REQUIRED
ON THIS APPLIANCE.
A three-wire, single-phase 60 hertz AC only
electrical supply is required.
A separate electrical supply is required on a
separately fused circuit. Do not fuse ground-
neutral.
See Chart C for receptacle voltage requirements,
proper fuse size, wire and wiring connections
which must conform with rating of the appliance.
Do not use an extension cord.
Chart-C
PLUG AND
RECEPTACLE
DATA
RECEPTACLE
PÍ ДТ
ДПР ^ OBOUND
FLAT BLADE риоцо
USETME-OELAY
FUSE
OR TIME
DELAY CtRCUrr
BREAKBI
RATING IN
AMPS
20
RECEPTACLE
VOLTAGE
(60 HERTZ
ACM AU
SiSTANCeS)
MODEL WITH
SERIAL PLATE
OF 230 VOLTS
(207 MIN,2S3
MAX.)
MODEL WITH
SERIAL PLATE
OF 230/208
VOLTS
(197.6 MIN
253 MAX )
SERIAL PLATE
AMPERES
up
through
16.0
MINIMUM
RECEPTACLE
WIRE SIZE
12 GAUGE
USE COPPER
WIRE ONLY
TYPE
OF BRANCH
CIRCUIT
SINGLE
OUTLET
ONLY
RECEPTACLE WIRING
RECEPTACLE WIRING should be at least as
large as size shown on electrical Chart C. Use
copper wire only. It is the personal responsibility
and obligation of the customer to provide
proper and adequate receptacle wiring installed
by a qualified electrician. OBSERVE NATIONAL
ELECTRICAL
CODE
AND
ALL
LOCAL
GOVERNING CODES AND ORDINANCES.
RECOMMENDED GROUNDING METHOD
For your personal safety, this appliance must be
grounded. This appliance is equipped with a
power supply cord having a 3-prong grounding
plug. To minimize possible shock hazard, the
cord must be plugged into a mating 3-prong
grounding type wall receptacle, grounded in
accordance with the National Electrical Code
and local codes and ordinances. If a mating wall
receptacle is not available, it is the personal
responsibility and obligation of the customer to
have a properly grounded 3-prong wall receptacle
installed by a qualified electrician.