For your air conditioner, Through-the-wall installation instructions, Caution – Whirlpool ACE094XM0 User Manual
Page 6: Important, Installation instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION INSTRUCTIONS
for Your Air Conditioner
Through-the-wall
Installation Instructions
•
To help avoid any installation prob
lems and to help assure trouble-free
performance of your new air condi
tioner, read these installation instruc
tions, as well as the operating instruc
tions
and
electrical,
requirements
before installing your upit.
•
Because this air conditioner weighs
from
approximately
125
to
200
pounds, it is recommended that you
have somebody help you install your
new unit and that you both use proper
lifting techniques to avoid personal
injury.
•
Inspect the condition of the window
where
the
air
conditioner
will
be
installed. Be sure it will support the
weight of the unit.
1
CAUTION:
•
Be sure air conditioner does not fall out of
window during installation.
•
Handle the air conditioner with care.
Watch out for the sharp metal fins on
the front and rear coils.
•
• Do not use the collected water for drinking
purposes. It is not sanitary.
C
THIS
APPLIANCE
MUST
BE
INSTALLED
ACCORDING
TO
ALL
APPLICABLE
CODES
AND ORDINANCES
• Unpack accessory parts shipped with cabinet
(see Figure 3) before installing your air
conditioner.
for
Do
DO
HEX HEAD
SCREW AND
Ntrr
Pick the right wall. First, decide what room(s)
you want to cool. Then choose a wall that
will allow the air-conditioned air to flow
freely and directly into the room(s) you want
cooled. Remember, it's difficult to move air
around corners. Choose a location that's
also near an electrical outlet. (Refer to the
ELECTRICAL
REQUIREMENT
pages
type of receptacle and wiring needed.)
not use an extension cord. CAUTION:
NOT LOCATE AIR CONDITIONER WHERE
PLASTIC
CABINET
FRONT
WILL
BE
EXPOSED TO A HEAT SOURCE THAT
RAISES
THE
SURFACE
TEMPERATURE
IN EXCESS OF 120°F.)
IMPORTANT:
Underwriters'
Laboratory,
Inc.,
listing
and all manufacturing warranties appli
cable to this air conditioner are res
cinded unless your unit is installed in
a proper cabinet. Refer to labels on
unit and inside the cabinet which state
cabinet type for matching your unit to
the correct cabinet.
Remove hardboard panel by removing the
two screws holding hardboard panel to front
of cabinet (see Figure 4). Release panel by in
serting finger in service-cord opening on left
side of cabinet and pushing outward. Install
cabinet
using
installation
instructions
on
hardboard panel.