M to stop and, Restart the dryer, Changing the setting – Whirlpool LT5100XS User Manual
Page 14: The automatic cycles
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
M To Stop and
3.
Restart the Dryer
To stop,
open the door (or turn
the Control Knob to the OFF area).
To restart,
close the door and
push the START Button.
4
.
Changing the Setting
The setting can be changed at any
time by turning the Control Knob
to a new setting.
The Cycle Control Knob should
point to an OFF area when the dryer Is
not Is use. If the dryer Is stopped
before the cycle Is finished, turn the
Cycle Control Knob to an OFF area.
The automatic cycles
The automatic cycles allow you
to select the degree of dryness you
prefer for the clothes being dried.
The Cycle Control Knob will not
move until the clothes load is
almost dry, or the COOL-DOWN
portion of the cycle has been
reached. After COOL-DOWN, the
knob automatically moves to an
OFF area and tumbling stops.
Use
AUTOMATIC
REGULAR to
dry heavy
and medium-
weight cotton items.
The load tumbles
without heat during the last 5 minutes.
This helps make the load easier to
handle.
PERMANENT
PRESS
Use
AUTOMATIC
PERMANENT
PRESS to dry
permanent
press, knits and other synthetic fabrics.
The load tumbles without heat during
the last 10 minutes.
This helps keep
wrinkles from setting in, and makes the
load easier to handle.
For the first few loads, set the Control
Knob to point to an * in either auto
matic cycle. When the dryer stops,
feel the dried items.
• If items are drier than you like, use a
setting to the right if the * the next
time you dry a similar load.
• If items are not as dry as you like,
use a setting to the left of the * the
next time you dry a similar load.
OVERDRYING CAN CAUSE
SHRINKAGE, STATIC CLING AND
DAMAGE TO SOME FABRICS.
14