For a rinse and spin, For a drain and spin, For a soak or pre-nash – Whirlpool LT5100XS User Manual
Page 12: Other operating instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily soiied ioads which
need more detergent. (Extra
detergent can require an extra rinse.)
1.
Push Controi Knob in.
2. Turn clockwise to any • on the
diai.
See above drawing.
3. Puii Controi Knob out. The washer
wili fill to selected level; agitate 2
minutes; drain and spin.
For a drain and spin
Your washer can be set to drain
and spin out water.
1. Push Controi Knob in.
2. Turn ciockwise to the bar just
before the OFF area in any cycle.
See above drawing.
3. Pull Control Knob out. The washer
will drain and spin.
For agitation and spin speeds in each cycle, see pages 8-11.
For a soak or pre-nash
For best results, use warm water
for soaking or pre-washing stained
iaundry.
Hot water can set stains.
1.
Use recommended amount of
detergent or pre-soak product.
2. Push Controi Knob in.
3. Turn clockwise to point at a
number in the SOAK or PRE
WASH Cycle.
4.
Pull Control Knob out. The washer
will start.
5. When the cycle is over, add de
tergent for the next seiected wash
cycie.
The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
Information In your “Laundry
Guide.”
To start the soak or pre-wash with agitation, the Cycle Control
Knob must point to a number.
12