Whirlpool EV200D - Manual (Page 3)

Setting the Cold Control...
To start, turn control to the middle of the dial
This setting will maintain zero zone temperatures
under normal operating conditions.
Using your freezer
Note: When freezer is first started the compressor
will run constantly until the cabinet is cooled. It
may take up to 6 to 8 hours or longer, depending
on room temperature and the number ot times
the freezer door is opened.
Afterthe cabinet is cooled the compressor will
turn on and oft as needed to keep freezer at
proper temperature.
Adjusting Cold Control...
• Turn control to higher number tor colder
temperatures
• Turn to lower number for less cold temperatures
Cooling Freezer First...
• Allow freezer to cool 6 to 8 hours before filling
with frozen food.
• Let it cool overnight before adding large
amount ot unfrozen food.
POWER SAVING CONTROL
SAVES
POWER
f a c t
OFF ON
REDUCES
EXTERIOR
MOISTURE
The Power Saving Control...
operates electric heaters. These heaters help
prevent moisture from forming on the outside of
the freezer when humidity is high.
• Use the OFF setting when humidity is low to save
electricity.
• Use ON only If moisture forms on outside of
freezer.
Exterior Signal Light...
automatically warns of any unexpected power
failure
Signal light
If the signal light is not glowing,
check:
for power interruption,
the power cord; it may be disconnected from
the outlet,
the signal light; it may be burned out.
To replace burned out signal light:
1. Unplug power cord from outlet.
2. Remove base grille. See page 4.
immediately 3. Unplug burned out light and replace with one
of same wattage and size. Signal light can be
ordered from your WFIIRLFOOL dealer. Part No.
530584.
4. Replace base grille. See page 4.
5. Plug power cord into outlet.