Before you plug it in, Install properly, Level freezer – Whirlpool EV200D User Manual
Page 2: Remove sales labels, Clean it, Plug it in
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before you plug it in
Before using your freezer, you are personally
responsible for making sure thaf if...
• is insfalled and leveled on a floor thaf will
hold the weight, and in an area suitable for
Its size and use.
• is conneoted only to the right kind of outlet,
with the right e l e c t r i c a l
s u p p l y a n d
grounding.
•
is used only for jobs expected of home
freezers
• is not near an oven, radiator or other heat
source.
is properly maintained,
is in a dry sheltered place,
is used in an area where the room tempera
ture will not exceed 110 F (43.3 C)
Is not run where there are explosive fumes.
is not used by children or others who may not
understand how it should be used,
is not loaded with food before it has time to
get properly cold.
Install Properly...
1. Check the strength of the floor. It should hold
the weight of fully loaded freezer
Pick a safe place, indoors, away from in
flammables such as gasoline.
Freezer may be installed flush against wall in
back and cabinets on each side.
2
.
3.
Level Freezer...
so that door will stay open at any position.
1. Remove base grille (see page4 ).
"
2. Starting with door hinge side,
turn left to raise corner.
3. Turn right to lower corner.
4. Check with level.
5. After freezer is loaded with
food, recheck with level.
Raise
Lower
Remove Sales Labels...
Remove the Consumer Buy Guide label and
any inside labels before using the freezer. Re
move any left over glue with rubbing alcohol.
Note:
DO NOT REMOVE the Tech Sheet fas
tened behind the base grille.
Clean It...
Clean your freezer before using it. See clean
ing instructions on pages.
Plug it in...
Recommended Grounding Method
A 120 Volt, 60 FIz., AC only, 15 ampere fused
electrical supply is required. It is recommended
that a separate circuit serving only this appli
ance be provided
The receptacle should not
be controlled by a wall switch or pull chain.
Do not use an extension cord.
See
individual
electrical
requirements
and
grounding
instruction
sheet
in
your
literature
package.