Whirlpool AC1052XS - Manual (Page 3)

Do not use rubbing alcohol or flammable toxic
solvents, such as acetone, gasoline, carbon
tetrachloride, etc. These can damage the material.
Do not use a sharp instrument or any harsh or
abrasive cleaners.
Energy Saving Tips
• Improve home insulation (seal doors, windows,
and close fireplace flue).
• Close blinds or drapes on sunny side of house.
Add window awnings.
Keep air filter clean. Don’t block air flow with
drapes or furniture.
Ventilate attic (high temperature levels add to
normal cooling load).
Try not to use heat producing appliances during
the hottest part of the day. Turn lights, radios,
televisions, and other appliances off when not
needed.
Keep heat registers and cool air returns closed
or blocked off so cooled air won’t escape.
Use a vent fan in areas in cooking, laundry or
bathing areas to pull out extra heat and moisture
near its source.
HOW TO START AND USE
YOUR AIR CONDITIONER
A warning
Electrical Shock Hazard
Be sure air conditioner control is set to UNIT
OFF before plugging in the unit. Do not use an
extension cord. Piug unit oniy into a grounded
electricai outiet. Failure to do so could result
in personal injury.
EXHAUST VENT
CONTROL
FAN SPEED
CONTROL
THERMOSTAT
OPEN CLOSED
Quiet Miser
UNIT
OFF
FAN MAX
ONLY COOL
QUIET REGULAR
COOL COOL
Whirlpool
To Start Your Air Conditioner
1. Set the EXHAUST VENT CONTROL to CLOSED
for best cooling results.
2. Set the FAN SPEED CONTROL to the desired
setting.
QUIET COOL................. for sleeping comfort
REGULAR COOL............. for normal cooling
MAX COOL.................. for maximum cooling
FAN ONL'Y................. for air circulation only
A caution
If you turn your air conditioner off, wait at
least two minutes before turning it back on or
you may biow a fuse or circuit breaker.
3. Turn THERMOSTAT CONTROL to the mid
(Number 6) setting. You can adjust the air
conditioner’s cooling performance by resetting the
thermostat control to a higher number for maximum
cooling. Lower the thermostat for less cooling. You
will need to experiment to find the setting which suits
you best.
When lowering the thermostat control setting, the
compressor (motor) may shut off. When the
compressor is turned off with either the fan speed
control or the thermostat control, wait 2-3 minutes
before restarting the air conditioner or turning the
compressor back on.