beautypg.com

Solving common ice maker problems, Attaching the ice maker to a water supply, Read all directions carefully before you begin – Whirlpool 2183013 User Manual

Page 11: Important, Tools required, Cold water supply, Ikwarning

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

U S I N G Y O U R R E F R I G E R A T O R

Solving common ice maker problems

PROBLEM

POSSIBLE CAUSE/SOLUTION

Ice crescents attached

• This is normal. They break apart easily. Shake bin

at corners

occasionally to keep cubes separated.

Ice maker will not

• ON/OFF lever is in the OFF (up) position. Lower lever to the

operate or Ice Is not

ON (down) position.

made fast enough

• Freezer is not cold enough. Adjust temperature control and

wait 24 hours.

Off-taste or odor In Ice

• New plumbing connections can cause discolored or off-

flavored ice. Discard the first few batches of ice.

• Cubes are stored too long. Throw them away and make a

new supply.

• Foods in freezer are not wrapped properly. See “Food

Storage Guide” on pages 20 and 21.

• Freezer and ice bin need to be cleaned. See page 16.

Attaching the ice maker to a water supply

Read all directions carefully before you begin.

ikWARNING

Electrical Shock Hazard

Disconnect electrical supply to refrig­

erator before installing.

Electrical drill must be grounded before

drilling holes in water line.

Failure to do so could result in death,

electrical shock, or serious injury.

IMPORTANT:

• Use copper tubing only and check for leaks.
• Install ice maker tubing in areas where

temperatures are above freezing.

Tools required:

• standard screwdriver
• yie-inch and V

2

-inch open-end wrenches or

2 adjustable wrenches

• Vi-inch nut driver
• Vi-inch drill bit
• Hand drill or electric drill (properly grounded)

NOTE:

Your appliance dealer has a kit

available with a V4-inch saddle type shut-off
valve, a union, and copper tubing.

Before purchasing, make sure a saddle type

valve complies with your local plumbing
codes. Do not use piercing type or yis-inch
saddle valve which reduces water flow and
clogs more easily.

Cold water supply

Ice maker water valve contains a flow

washer which is used as a water pressure

regulator. The ice maker needs to be

connected to a cold water line with water
pressure limitations of 20-120 PSI. If a
problem occurs, call your utility company.

IMPORTANT:

• It may take up to 24 hours for your ice

maker to begin producing ice.

• If operating the refrigerator before install­

ing the water connection, turn ice maker to

the OFF position to prevent operation
without water.

• All installations must be in accordance with

local plumbing code requirements.

INSTALLATION IS NOT WARRANTED

BY REFRIGERATOR OR ICE MAKER

MANUFACTURER.

11