Whirlpool ET1 8MK - Manual (Page 6)

Adjusting shelves...
Shelves can be adjusted to match the way you use
your refrigerator. Glass shelves are strong enough to
hold bottles, milk and other heavy food items.
To remove glass shelves:
1. Tilt up at front.
2. Lift up at back
3. Pull shelf straight out.
Glass shelves are
heavy. Be careful
To replace:
1. Guide the rear hooks into the slots in the shelt
supports.
2. Tilt up front of shelf until hooks drop into slot. Lower
front of shelf to level position.
To remove door shelf:
• Lift up and out
Optional automatic ice maker...
On
To replace:
• Insert hooks into guides
on both sides.
• Push down
Removing the freezer shelf.
• Lift front slightly.
• Lift back off supporfs.
• Replace in reverse order.
Lift the Front
Then the Back
If you have the automatic ice maker accessory or
plan to add one later (Part No. ECKMF-6), there are
a few things you will want to know
• The ON/OFF lever is a wire signal arm.
Down...for making ice automatically:
Up...to shut oft the ioe maker.
• Shake the bin occasionally to keep cubes sepa­
rated, and to obtain increased storage capacity.
• It is normal for ice crescents to be attached by a
corner. They will break apart easily.
• You will hear water running when ice maker is
working. You'll hear ice fall into the bin. Don't let
these sounds bother you.
• The ice maker will not operate until the freezer is
cold enough to make ice. This can take overnight,
• Because of new plumbing connections, the first
ice may be discolored or oft-flavored. Discard the
first few batches of ice.
• If ice is not being made fast enaugh and more ice
is needed, turn the Refrigerator Control toward a
higher number. Wait a day and, if necessary, turn
the Freezer Control toward A.
• If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
position.
• If cubes are staed too long, they may develop an
off-flavor,..like stale water. Throw them away. They
will be replaced. Cubes in the ice bin can also
become smaller by evaporation.
Adjusting crisper
Humidity Control...
You can control the amount of humidity in the mois­
ture-sealed crisper,
1. The control can be adjusted to any setting be­
tween LO and Fll
2. LO (open] lets moist
air out of crisper for
best storage of fruits
and vegetables
with skins,
3. HI (closed] keeps
moist air in the cris­
per for best storage
of fresh leafy vege­
tables.
Changing the light hulb...
Unplug the refrigerator first.
1. Reach behind control console to find bulb.
2. Remove bulb
3.
Replace with appliance bulb only