Install properly, Level refrigerator-freezer, Remove sales labels – Whirlpool ET1 8MK User Manual
Page 4: Clean it, Plug it in
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Install properly.
1, Allow'/?" (.2 cm) space on each side and at top for
ease of installation,
2 The refrigerator back can be flush against the
wall
3, If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be
opened wider.
Level refrigerator-freezer...
Left to Lower
1, Remove base grille (see page 8)
2, To raise front, turn each screw to the right,
3, To lower front, turn each screw to the left,
4, Check with level.
Remove sales labels...
Remove the Consumer Buy Guide label and other
nside labels before using the refrigerator. Any glue
left can be taken off with rubbing alcohol.
Do not remove the label giving operating in
structions for the Refrigerator and Freezer Con
trols or the Tech Sheet fastened under the
refrigerator at the front.
Clean it...
Clean your refrigerator before using it. See clean
ing instructions on page 8
Plug it in...
3-prong
grounding type
wall receptacle
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz,, AC only, 15 or 20 ampere fused
electrical supply is required. It is recommended that
a separate circuit serving only this appliance
be provided.
Do not use an extension cord. Use a receptacle
which cannot be turned off with a switch or pull
chain. See individual electrical requirements and
grounding instruction sheet in your literature
package.