Removing the base grille – Whirlpool ED20PK ED22PK User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

U S I N G Y O U R R E F R I G E R A T O R

Solving common ice maicer probiems

PROBLEM

POSSIBLE CAUSE/SOLUTION

Ice crescents attached

at corners

• This is normal. They break apart easily. Shake bin occasion

ally to keep cubes separated.

Ice maker will not

operate or ice is not

made fast enough

• ON/OFF lever is in the OFF (up) position. Lower lever to the

ON (down) position.

• Freezer is not cold enough. Adjust temperature controls and

wait 24 hours. (See “Changing the control settings” on
page 8.)

Off-taste or odor in ice

• New plumbing connections can cause discolored or off-

flavored ice. Discard the first few batches of ice.

• Cubes are stored too long. Throw them away and make a

new supply.

• Foods in freezer are not wrapped properly. See “Food

Storage Guide” on pages 20 and 21.

• Freezer and ice bin need to be cleaned. See pages 17

and 18.

Removing the base grille

To remove the grille:

1. Open both doors.

2. Pull base grille forward to release the

support tabs from the metal clips.

3. Do not remove Tech Sheet

fastened

behind the grille.

To replace the grille:

1. Line up grille support tabs with metal clips.

2. Push firmly to snap into place.

Close the doors.

See cleaning instructions for defrost pan and
condenser coils on page 18.

Condenser coils