Whirlpool 3360462 - Manual (Page 19)

LAUNDRY TIPS
Solving laundering problems
Most laundering problems are easily solved if you understand the cause. Check the following list
for problems you may have and possible causes. If you need additional help, check the “Assis­
tance or Service” section of this book.
PROBLEM CAUSE
Brown, yellow
stains • Chlorine staining
• Iron in water heater or pipes
• Iron and manganese in water
Dye transfer • Improper sorting
• Load not immediately removed from washer after end of cycle
Gray whites,
dingy colors • Improper sorting
• Water temperature too low
• Not enough detergent
• Using soap in very hard water (use detergent if you have hard water)
Greasy looking
spots • Undiluted fabric softener or fabric softener poured directly on load
• Fabric softener in wash water
• Not enough detergent
Lint • Improper sorting
• Paper or tissue in pockets
• Pilling being mistaken for lint
• Overloading
• Not enough detergent
• Clogged lint filter (models with manual clean lint filter)
Load too wet
after spin • Cold rinses
• Lid is opened before spinning is completed
Shrinking • Fabric type (some knits stretch during manufacturing-laundering returns
fabric to original size)
• Care label directions not followed
Snags, rips, holes • Items damaged before washing
• Misuse of chlorine bleach
• Sharp articles not removed from pockets
• Overloading
• Fasteners not fastened
Stiff, rough fabrics
(usually cottons) • Using soap in very hard water (use detergent if you have hard water)
• Not enough detergent
• Line drying
Twisting, tangiing • Overloading
• Improper loading (do not wrap large items around agitator)
Wrinkiing • Overloading
• Load not immediately removed from washer after end of cycle
• Improper rinse temperature
• Cycle selection is incorrect (based on fabric type)
Yeliow areas
(from body oiis) • Water temperature too low
• Not enough detergent
19