Instau properly, Remove sales labels, Plug it in – Whirlpool ET22ZM User Manual
Page 4: Level refrigerator-freezer, Clean it, Plug it in. level refrigerator-freezer
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
InstaU properly...
Allow У
2
inch (125 cm) space on each side and at
the top of the refrigerator for ease of installation
If the refrigerator is to be against a wall, you m'ght
want to leave extra space so the door can be
opened wider.
The refrigerator back can be flush against the wall
Remove sales labels...
Remove the Consumer Buy Guide label, tape and
any
inside
labels before using the refrigerator
To remove any remaining glue:
1, Rub briskly with thumb to make a ball then remove
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or
toxic soivents, such as acetone, gasoline, car
bon tetrachioride, etc. These can damage the
materiai.
NOTE: DO NOT REMOVE ANY PERMANENT IN
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it...
Clean your refrigerator
before using it.
See cleaning instructions
on page 9
Plug it in.
Level refrigerator-freezer..
1
, Remove base grille (see page
7
),
2, To raise front, turn each screw to the right,
3, To lower front, turn each screw to the left,
4, Check with level.
3-prong grounding
type wall receptacle
3-prong
grounding plug
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz,, AC only 15 or 20 ampere fused
and properly grounded electrical supply is re
quired, It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recep
tacle which cannot be turned oft with a switch
or puil chain.
See individual electrical require
ments and grounding instruction sheet in your liter
ature package