Cisco ATM and Layer 3 Switch Router OL-1911-05 - Manual (Page 4)

24-4
ATM and Layer 3 Switch Router Software Configuration Guide
OL-1911-05
Chapter 24 Configuring ATM Router Module Interfaces
Overview of the ATM Router Module
• IP fragmentation support.
• IP 6-path load balancing support.
• Supports OAM-based PVC management.
• Supports Bridge Group Virtual Interface (BVI).
• Supports integrated routing and bridging (IRB).
Note The Catalyst 8540 MSR enhanced ATM router module does not support LANE clients.
The ATM router module has no external interfaces. All traffic is sent and received through internal
interfaces to the switching fabric. The Catalyst 8540 MSR enhanced ATM router module has two
internal ports.
Catalyst 8540 MSR ATM Router Module Features
The Catalyst 8540 MSR ATM router module offers the following benefits:
• Interoperates with all of the Layer 3 switching interface modules available for the
Catalyst 8540 CSR chassis. For more information on the Catalyst 8540 CSR Layer 3 interface
modules, refer to the ATM and Layer 3 Module Installation Guide.
• Provides an integrated high performance link between ATM and Layer 3 cards. The ATM router
module provides an aggregate switching capacity of 2 Gbps between ATM and Layer 3 ports
(2 x 1-Gbps interfaces per module). Data transfers to the switch core at the rate of 1 Gbps.
• Simplifies management.
• Hot-swappable.
• Occupies only one slot in the chassis.
• Supports LANE clients (LECs).
• Supports RFC 1483 SVCs and PVCs with AAL5 SNAP encapsulation.
• Supports RFC 1577 SVCs and PVCs.
• Supports Soft PVCs
• Supports VBR
• Supports Shaped Tunnels
• Supports OAM-based PVC management.
• Supports BVI.
• Supports IRB.
The ATM router module has no external interfaces. All traffic is sent and received through internal
interfaces to the switching fabric. The Catalyst 8540 MSR enhanced ATM router module has two
internal ports.