Cisco ATM and Layer 3 Switch Router OL-1911-05 - Manual (Page 25)

24-25
ATM and Layer 3 Switch Router Software Configuration Guide
OL-1911-05
Chapter 24 Configuring ATM Router Module Interfaces
Configuring Bridging
Switch(config)# interface atm 3/0/0
Switch(config-if)# atm pvc 2 200 interface atm 1/0/0 0 200
Switch(config-if)# bridge-group 5
Switch(config-if)# end
Switch(config)# interface fastethernet 0/0/0
Switch(config-if)# no cdp enable
Switch(config-if)# bridge-group 5
Switch(config-if)# end
Switch(config)# bridge 5 protocol ieee
Configuring Packet Flooding on a PVC
Typically, a specific static map list configuration is not required for bridging to occur. In case of packet
flooding, the bridging mechanism individually sends the packet to be flooded on all PVCs configured on
the interface. To restrict the broadcast of the packets to only a subset of the configured PVCs you must
define a separate static map list. Use the broadcast keyword in the static-map command to restrict
packet broadcasting.
Command Purpose
Step 1 Switch(config)# interface atm card/subcard/port
Switch(config-if)#
Specifies the interface to configure on the ATM
router module.
Step 2 Switch(config-if)# no ip address Disables IP processing.
Step 3 Switch(config-if)# no ip directed-broadcast Disables the translation of directed broadcasts to
physical broadcasts.
Step 4 Switch(config-if)# map-group number Enters the map group name associated with this
PVC.
Step 5 Switch(config-if)# atm pvc 2 vci-A interface atm
card/subcard/port vpi-B Configures a PVC.
Note The VPI number on the ATM router
module interface must be 2.
Step 6 Switch(config-if)# bridge-group number Assigns the interface to a bridge group.
Step 7 Switch(config-if)# end
Switch(config)#
Returns to global configuration mode.
Step 8 Switch(config)# map-list name
Switch(config-map-list)#
Creates a map list by naming it, and enters
map-list configuration mode.
Step 9 Switch(config-map-list)# bridge atm-vc number
broadcast Enables packet flooding on a PVC.