Cisco ATM and Layer 3 Switch Router OL-1911-05 - Manual (Page 23)

24-23
ATM and Layer 3 Switch Router Software Configuration Guide
OL-1911-05
Chapter 24 Configuring ATM Router Module Interfaces
Configuring Classical IP over ATM in an SVC Environment
Displaying the IP-over-ATM Interface Configuration
To show the IP-over-ATM interface configuration, use the following EXEC commands:
Examples
In the following example, the show atm arp-server command displays the configuration of the interface
ATM 1/0/0:
Switch# show atm arp-server
Note that a '*' next to an IP address indicates an active call
IP Address TTL ATM Address
ATM1/0/0:
* 10.0.0.5 19:21 4700918100567000000000112200410b0a108140
The following example displays the map-list configuration of the static map and IP-over-ATM
interfaces:
Switch# show atm map
Map list ATM1/0/0_ATM_ARP : DYNAMIC
arp maps to NSAP 36.0091810000000003D5607900.0003D5607900.00
, connection up, VPI=0 VCI=73, ATM2/0/0
ip 5.1.1.98 maps to s 36.0091810000000003D5607900.0003D5607900.00
, broadcast, connection up, VPI=0 VCI=77, ATM2/0/0
Map list ip : PERMANENT
ip 5.1.1.99 maps to VPI=0 VCI=200
Command Purpose
show atm arp-server Shows the ATM interface ARP configuration.
show atm map Shows the ATM map list configuration.