Whirlpool 3360464 - Manual (Page 6)

OPERATING YOUR WASHER
6. (OPTIONAL STEP) If your washer has
an Extra Rinse Selector, you can set it
to On to add an additional rinse to the
end of the wash cycle.
• Use the extra rinse option when using
extra detergent for the Super Wash
cycle or any of the following cycles:
Regular, Permanent Press, Knits
Gentle, or Woollens.
• Before a cycle starts, select Extra Rinse
On. The washer automatically adds an
extra rinse and spin to the cycle.
• If you do not want an extra rinse and
spin, select Extra Rinse Off.
7. Push in and turn the Cycle Control
Knob clockwise. Stop when the indica­
tor on the outer ring points to the
number in the wash cycle you want.
• The numbers are minutes of wash time.
• The cycles are described on pages 7-9.
8
.
Pull out Cycle Control Knob to start
washer.
9. (OPTIONAL STEP) If desired, add
measured liquid chlorine bleach after
the washer starts agitating.
See
page 11.
Knob Selector
Stopping/restarting your
washer
• To
stop
the washer at any time, push in
the Cycle Control Knob.
• To
restart
the washer, close the lid (if
necessary) and pull out the Cycle
Control Knob.
Selecting a cycle and time
Use the information in this section to help
you make the best cycle selections for your
wash loads. Each cycle is designed for
different types of fabrics and soil levels.
• The washer pauses briefly throughout
each cycle. These pauses are normal for
washer operation.
• Refer to page 10 to help you understand
what happens during a wash cycle.
Cycles may vary with model