Whirlpool 3360464 - Manual (Page 10)

OPERATING YOUR WASHER
What happens in each cycle
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to
the selected load size) before agitation and
timing start. The washer begins agitating
immediately after filling; agitation can occur
with the washer lid up or down. After agita­
tion starts, the Cycle Control Knob turns
clockwise until it points to an OFF area and
the cycle ends.
WASH
The washer pauses briefly throughout
each cycle.
These pauses are normal for
washer operation.
RINSE
Fill
a
Wash selected time
Drain (or partial drain+)
No agitation
tJhe Permanent Press cycle partially
drains, fills, agitates briefly, and drains.
Spin
....... Fill
m
Rinse
Drain-No agitation
Spin-Spray rinse
Spin
A
Off
MAGIC CLEAN lint filter
The lint filter at the bottom of the washer
basket cleans itself. During agitation, wash
and rinse water passes over the filter,
separating the lint from the water. The lint is
then spun away from the filter and out of the
system during the spin part of the cycle.
If your washer drains into a tub, remove
any lint collected in the tub or strainer.
MAGIC CLEAN
lint filter
10