For heating, Using the exhaust control – Whirlpool ACE082XS0 User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

For Heating

NOTE: This product Is not designed to be used as a primary heat souroe. It Is Intended for
supplemental heating only.

LOHEAT
for reduced air

movement with heat.
HI HEAT

for maximum air

movement with heat.

Turn THERMOSTAT CONTROL to the mid

(number 6) setting. You can adjust the air con
ditioner's heating performance by resetting the
thermostat controi to a lower number for more
heat. Turn to a higher number for iess heat.

Model ACH082 ONLY

Use of the heat settings on this modei activates a reverse cycie operation that works as a heat pump.

It changes the operating mode of the refrigeration system to provide supplemental heat for chilly days
and evenings. When raising the thermostat in this heating mode, the compressor (motor) may shut off.
When the compressor is turned off with either the fan speed control or the thermostat control, wait 2-3
minutes before restarting the air conditioner or turning the compressor back on. This should prevent
blowing a fuse or tripping a circuit breaker. Use of this feature is not recommended when the
outside temperature is below 45°F.

Using the Exhaust Control

This control setting can be used to draw stale or smoky air from the room or to circulate air in the

room, without cooling or heating. NOTE: Make sure the exhaust vent control Is returned to the

CLOSED setting when cooling, heating or room air circulation is desired. Energy efficiency is
decreased when operating In EXHAUST and cooling or heating at the same time.

1. To exhaust room air:

• Set EXHAUST VENT control to OPEN.

• If cooling is desired, set FAN SPEED

CONTROL to desired COOL setting.

• If heating is desired, set FAN SPEED

CONTROL to desired HEAT setting.

• If cooling or heating is not required, set

FAN SPEED CONTROL to FAN ONLY.

To circulate room air:

• Set EXHAUST VENT control to CLOSED.
• If cooling is desired, set FAN SPEED

CONTROL to desired COOL setting.

• If heating is desired, set FAN SPEED

CONTROL to desired HEAT setting.

• If cooling or heating is not required, set

FAN SPEED CONTROL to FAN ONLY.