Energy saving tips, Using your air conditioner, To start your air conditioner – Whirlpool ACE082XS0 User Manual
Page 3: For cooling or air circulation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To remove the Consumer Buy Guide label
and energy rating label lift one edge and pull
straight off.
To remove any remaining glue:
1. Rub briskly with thumb to make a baii, then
remove.
-or-
2.
Soak area with a iiquid hand dishwashing
detergent before removing giue as
described in step 1.
Do not use rubbing alcohol or flammable
toxic solvents, such as acetone, gasoline,
carbon tetrachloride, etc. These can damage
the material.
Do not use a sharp instrument or any harsh
or abrasive cleaners.
Energy Saving Tips
• improve home insulation (seal doors, win
dows. and ciose firepiace flue).
• Close blinds or drapes on sunny side of
house. Add window awnings.
• Keep air filter clean. Don't block air flow with
drapes or furniture.
• Ventilate attic (high temperature levels add
to normal cooling load).
• Try not to use heat producing appliances
during the hottest part of the day. Turn lights,
radios, televisions and other appliances off
when not needed.
• Keep heat registers and cool air returns
closed or blocked off so cooled air won’t
escape.
• Use a vent fan in cooking, laundry or bathing
areas to pull out heat and moisture near its
source.
Using your air conditioner
To Start Your Air Conditioner
A WARNING: To prevent electrical hazard,
plug unit only into electrical outlet.
DO NOT use an extension cord.
EXHAUST VENT
CONTROL
FAN SPEED
CONTROL
THERMOSTAT
• Set the EXHAUST VENT CONTROL to CLOSED
for best cooling or heating results.
• Set the FAN SPEED CONTROL to the desired
setting.
For Cooling or Air Circulation
QUIET COOL..................... for sleeping comfort
MAX COOL .................... for maximum cooling
FAN ONLY...................... for air circulation only
Turn THERMOSTAT CONTROL to the mid
(number 6) setting. Adjust the air conditioner's
cooling performance by resetting the ther
mostat control to a higher number for max
imum cooling. Lower the thermostat for less
cooling. You will need to experiment to find the
setting which suits you best.
CAUTION: If you turn your air conditioner
off, wait of least two (2) minutes before
turning It back on or you may blew a fuse.
When lowering the thermostat control setting,
the compressor (motor) may shut off. When the
compressor Is turned off with either the system
control or the thermostat control, wait 2-3
minutes before restarting the air conditioner
or turning the compressor back on.