Install properly, Remove sales labels, Level refrigerator-freezer – Whirlpool ET20NK User Manual
Page 4: Plug it in
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Install properly...
1. Allow /2 inch (1.25 cm) space on each side and
at the top of the refrigerator for ease of
installation.
2.
If the refrigerator is to be against a wall, you
might want to leave extra space so the door
can be opened wider.
3.
The refrigerator back can be flush against the
wall.
Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any inside labels before using the re
frigerator To remove any remaining glue:
1.
Rub briskly with thumb to make a ball then
remove.
OR
2.
Soak area with liquid hand dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN
STRUCTIONS LABELS INSIDE YOUR REFRIGER
ATOR.
Do not remove the Tech sheet fastened under
the refrigerator at the tront.
Level refrigerator-freezer...
1. Remove base grille (see page 7).
2.
To raise front, turn screw in the direction shown
3.
To lower front, turn screw in the direction shown,
4.
Check with level,
5.
Replace base grille (see page 7).
Plug it in...
3-PRONG GROUNDING
TYPE WALL RECEPTACLE
REFRIGERATOR
POWER CORD
3-PRONG
GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
required. It is recommended that a separate cir
cuit serving only this appliance be provided.
Do not use an extension cord. Use a recepta
cle which cannot be turned oft with a switch or
pull chain. See individual electrical requirements
and grounding instruction sheet in your literature
package.